Description

• Bonds, protects and rebuilds for a permanent repair
• Abrasion resistant – great for bonding heavy use items
• Waterproof – bond remains secure even when exposed to water

INSTRUCTIONS

Follow these step-by-step directions when using Shoe GOO Boots & Gloves:  DIRECTIONS: Read directions and test small area before use.

1. Surface should be clean, dry and free of dirt.
2. Puncture seal in neck of tube using pointer cap. Ideal application temperature range is 50 to 90 ºF (10 to 32 ºC). However, fully cured adhesive can withstand temperatures from -40 to 180 ºF (-40 to 82 ºC) intermittently.
3. Apply directly to each surface to be bonded or repaired. Allow to partially cure, approximately 2 minutes before mating surfaces. Hardens by solvent evaporation and forms an immediate bond that is difficult to reposition after both adhesive-coated surfaces are placed in contact with each other and sufficient pressure is exerted to establish full contact.
4. Allow repair to cure for 24 hours. Depending on materials and temperature, maximum strength may not be reached for 48 to72 hours.
5. For future easy cap removal, apply a thin coat of petroleum jelly to the threads of  the tube before replacing the cap.
6. Clean uncured adhesive with acetone or citrus-based solvents. Cured material may be removed by cutting or scraping.
7. WATERPROOFING/PROTECTING GLOVES: To build a thick coating over high wear areas and along seams, use thin coats (spread with a disposable tool) to build a thick coating, allowing each layer to set 3-4 hours.

Coating Boot or Shoe Toes:

1. Tape edge of area to be protected with masking or painter’s tape.
2. Apply SHOE GOO Boots & Gloves over surface.
3. Quickly spread with throw-away spreader (such as a popsicle stick) before adhesive skins over. Note: Use thin coats to build a thick coating. However, make sure each coat is applied evenly.
4. Let set 3 to 4 hours between coatings.
5. Remove tape immediately after spreading.
6. Product will self-level after about 30 minutes and set smoothly.